H3C Technologies H3C SecPath F1000-E - Manual (Page 662)

4
Table 2 describes the protocol group configuration items.
Table 2 Protocol group configuration items
Item Description
Group ID ID of the protocol group to be created.
Protocol(s)
Add one or more protocols to the protocol group. The
protocols available for selection depend on the
loaded signature file; each protocol corresponds to a
P2P application.
Note that there are two protocol control levels:
Filter: To block the traffic of the specified protocol.
CBR: To limit the traffic of the specified protocol.
The control level support varies with different
protocols. The supported control level is marked in
brackets behind each protocol on the Web interface.
All protocols in a protocol group must support the
same control level as configured. Traffic control is not
available for any protocol that does not support the
configured control level.
Return to
P2P traffic control configuration task list .
Viewing Traffic Statistics
Select Identification > P2P Identify > Traffic Statistics from the navigation tree to enter the
page shown in Figure 5 .
Figure 5 View traffic statistics
Table 3 gives detailed descriptions of the traffic statistics.