H3C Technologies H3C SecPath F1000-E - Manual (Page 163)

1
Device Reboot
Device Reboot Overview
Device reboot allows you to reboot a device through the Web interface.
Configuring Device Reboot
Select Device Management > Reboot from the navigation tree to enter the rebooting device
configuration page, as shown in
Figure 1 .
Figure 1 Device reboot configuration page
Click Apply to reboot the device.
If you select Check whether the configuration is saved to the configuration file for next
boot, the device will do the related checking before rebooting. If finding that the current configuration
is not saved in the configuration file to be used at next boot, the system will prompt that the device cannot
reboot.
Device Reboot Configuration Example
Network requirements
The IP address and mask of the interface on Device A and those of Host A are shown in Figure 2 . It is
required to reboot Device A through the Web interface on Host A.
Figure 2 Network diagram for device reboot
Configuration procedure
# Configure Device Reboot.
• Select Device Management > Reboot from the navigation tree.