H3C Technologies H3C SecPath F1000-E - Manual (Page 318)

23
Table 5 describes the OSPF interface information.
Table 5 OSPF interface information
Item Description
Interface Name Interface name
IP Address
IP address of the interface
In case of IP unnumbered, the IP address of the borrowed interface is displayed.
Area ID ID of the area to which the interface belongs
Cost Cost for the interface
DR Priority DR priority for the interface
State
Current state of the interface, which can be:
• Down, indicating no packet is sent or received through the interface.
• Loopback
• Waiting, indicating the interface starts to send and receive Hello packets and
attempts to find the DR and BDR on the network.
• P-2-P, indicating the interface will send Hello packets at the hello interval, and
attempts to establish adjacency with the peer router.
• DR, indicating the router is a designated router (DR) of the network.
• BDR, indicating the router backup designated router (BDR) of the network.
• DROther, indicating the router is neither a DR nor a BDR of the network.
Return to
OSPF configuration task list .
Displaying OSPF Neighbor Information
Select Network > Routing Management >OSPF from the navigation tree to enter the OSPF
configuration page. After you complete OSPF area configurations, click Show Peer on the Show
Information tab to display the OSPF neighbor information, as shown in
Figure 26 .
Figure 26 Display OSPF neighbor information
Table 6 describes the OSPF neighbor information.
Table 6 OSPF neighbor information
Item Description
Peer Router ID ID of the neighbor router