Configuration procedure, Figure 7 – H3C Technologies H3C SecPath F1000-E User Manual
Page 421
13
Figure 7 Network diagram for RADIUS configuration
Internet
Device
Telnet user
192.168.1.58/24
RADIUS server
10.1.1.1/24
GE0/1
192.168.1.70/24
GE0/2
10.1.1.2/24
Configuration procedure
Step1
Configure the RADIUS server
When the RADIUS server runs CAMS:
NOTE:
This example assumes that the RADIUS server runs CAMS Server Version 2.10-R0210.
# Add an access device.
Log into the CAMS management platform and select System Management > System
Configuration from the navigation tree. In the System Configuration window, click Modify of
the Access Device item, and then click Add to enter the Add Access Device window and perform
the following configurations as shown in
:
Figure 8 Add an access device
•
Specify the IP address of the device as 10.1.1.2.
•
Set both the shared keys for authentication and accounting packets to expert.
•
Select Device Management Service as the service type.
•
Specify the ports for authentication and accounting as 1812 and 1813 respectively.