H3C Technologies H3C SecPath F1000-E - Manual (Page 499)

5
Figure 5 Network diagram for configuring static ARP entries
Configuration procedure
NOTE:
Before the following configurations, if the working mode of interface GigabitEthernet 0/1 is router
mode, select Device Management > Interface from the navigation tree and change the working mode of
the interface to bridge mode.
# Create VLAN 10.
• Select Network > VLAN > VLAN from the navigation tree, and click Add. The VLAN
configuration page appears, as shown in
Figure 6 .
Figure 6 Create a VLAN
• Type 10 for VLAN ID.
• Click Apply.
# Add GigabitEthernet 0/1 to VLAN 10.
• Click the icon corresponding to VLAN 10 on the VLAN page, and modify the VLAN
configuration, as shown in Figure 7 .