H3C Technologies H3C SecPath F1000-E User Manual
Page 386
18
Figure 13 Enable IP multicast routing
•
Select Enable from the drop-down list to enable multicast routing.
•
Click Apply.
•
Select Network > Routing Management > IGMP from the navigation tree to enter the
Interface Configuration page.
•
Click the icon corresponding to GigabitEthernet 0/1 to enter its configuration page shown in
.
Figure 14 Enable IGMP
•
Select Enable from the drop-down list to enable IGMP.
•
Specify the IGMP version as 2.
•
Click Apply.
•
Select Network > Routing Management > PIM from the navigation tree to enter the
Interface Configuration page.
•
Click the icon corresponding to GigabitEthernet 0/1 to enter its configuration page shown in
.
Figure 15 Enable PIM-DM
•
Specify the working mode as PIM-DM and click Apply.
•
Click the icon corresponding to GigabitEthernet 0/0 to enter its configuration page.
•
Specify the working mode as PIM-DM and click Apply.
The configuration on Device B is similar to that on Device A. Detailed configuration procedures are
omitted here.
# On Device C, enable IP multicast routing and enable PIM-DM on each interface.