H3C Technologies H3C SecPath F1000-E - Manual (Page 729)

17
Return to IPsec configuration task list .
Viewing Packet Statistics
Select VPN > IPSec > Statistics from the navigation tree to view packet statistics, as shown in Figure
21 .
Figure 21 Packet statistics
Return to
IPsec configuration task list .
IPsec Configuration Example
Network requirements
• As shown in Figure 22 , an IPsec tunnel is established between Device A and Device B to protect
traffic between subnet 10.1.1.0/24 and subnet 10.1.2.0/24.
• The security protocol is ESP, encryption algorithm is DES, and authentication algorithm is SHA-1.
Figure 22 Network diagram for IPsec configuration
Configuration procedure
Step1 Configure Device A
# Assign IP addresses for the interfaces and then add them to target zones. (Omitted)
# Define ACL 3101 to permit packets from subnet 10.1.1.0/24 to subnet 10.1.2.0/24.