5 using the boundary-scan chain, 6 using the on-chip debug system – Rainbow Electronics ATmega128RFA1 User Manual
Page 438
438
8266A-MCU Wireless-12/09
ATmega128RFA1
selects a particular Data Register as path between TDI and TDO and controls the
circuitry surrounding the selected Data Register.
•
Apply the TMS sequence 1, 1, 0 to re-enter the Run-Test/Idle state. The instruction
is latched onto the parallel output from the Shift Register path in the Update-IR state.
The Exit-IR, Pause-IR, and Exit2-IR states are only used for navigating the state
machine.
•
At the TMS input, apply the sequence 1, 0, 0 at the rising edges of TCK to enter the
Shift Data Register – Shift-DR state. While in this state, upload the selected Data
Register (selected by the present JTAG instruction in the JTAG Instruction Register)
from the TDI input at the rising edge of TCK. In order to remain in the Shift-DR state,
the TMS input must be held low during input of all bits except the MSB. The MSB of
the data is shifted in when this state is left by setting TMS high. While the Data
Register is shifted in from the TDI pin, the parallel inputs to the Data Register
captured in the Capture-DR state is shifted out on the TDO pin.
•
Apply the TMS sequence 1, 1, 0 to re-enter the Run-Test/Idle state. If the selected
Data Register has a latched parallel-output, the latching takes place in the Update-
DR state. The Exit-DR, Pause-DR, and Exit2-DR states are only used for navigating
the state machine.
As shown in the state diagram, the Run-Test/Idle state need not be entered between
selecting JTAG instruction and using Data Registers, and some JTAG instructions may
select certain functions to be performed in the Run-Test/Idle, making it unsuitable as an
Idle state.
Note that independent of the initial state of the TAP Controller, the Test-Logic-Reset
state can always be entered by holding TMS high for five TCK clock periods. For
detailed information on the JTAG specification, refer to the literature listed in
28.5 Using the Boundary-scan Chain
A complete description of the Boundary-scan capabilities are given in the section
1149.1 (JTAG) Boundary-scan" on page 441
.
28.6 Using the On-chip Debug System
As shown in Figure 28-1, the hardware support for on-chip debugging consists mainly
of
•
A scan chain on the interface between the internal AVR CPU and the internal
peripheral units.
•
Breakpoint unit.
•
Communication interface between the CPU and JTAG system.
All read or modify/write operations needed for implementing the debugger are done by
applying AVR instructions via the internal AVR CPU Scan Chain. The CPU sends the
result to an I/O memory mapped location which is part of the communication interface
between the CPU and the JTAG system.
The Breakpoint Unit implements Break on Change of Program Flow, Single Step Break,
two program memory breakpoints and two combined breakpoints. Together, the four
breakpoints can be configured as either:
•
4 single program memory breakpoints;
•
3 single program memory breakpoint + 1 single data memory breakpoint;
•
2 single program memory breakpoints + 2 single data memory breakpoints;