Allied Telesis AT-S60 - Manual (Page 98)

Chapter 5: SNMPv1 and SNMPv2c Configuration
Section I: Basic Features 98
D - Select D to disable the SNMP Community.
The following prompt is displayed:
Do you want to change Community Status? (Y/N):
[Yes/No]->
10. Choose one of the following selections:
Y - Select Y to change the Community Status.
N - Select N to retain the Community Status.
11. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Changing the Community Open Access Mode
To change the Community Open Access Mode, perform the following
procedure.
1. From the Main Menu, type 5 to select System Menu.
The System Menu is shown in Figure 5 on page 51.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown in Figure 11 on page 59.
3. From the Configure System Menu, type 1 to select Configure System
Software.
The Configure System Software Menu is shown in Figure 12 on
page 60.
4. From the Configure System Software Menu, type 8 to select
Configure SNMP.
The Configure SNMP Menu is shown in Figure 22 on page 87.
5. To configure SNMPv1 and SNMPv2c parameters, type 3 to select
Configure SNMPv1 & SNMPv2c Community.
The Configure SNMPv1 & SNMPv2c Community Menu is shown in
Figure 23 on page 89.
6. To modify SNMP Community attributes, type 3 to select Modify SNMP
Community.
The Modify SNMPv1 & SNMPv2c Community Menu is shown in
Figure 24 on page 93.
7. To allow access to an SNMP community, type 5 to select Set
Community Open Access.
The following prompt is displayed:
Enter SNMP Community Name: