Allied Telesis AT-S60 - Manual (Page 737)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 737
A warning message is displayed. Click OK to remove the Target
Parameters Table entry.
5. To save your changes, return to the General Tab and click Save
Changes.
Modifying a
Target
Parameters
Table Entry
To modify an SNMPv3 Target Parameters Table entry, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
Target Parameters Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Parameters Table Page is shown in Figure 261
on page 733.
4. Click the circle next to the Target Parameters Table entry that you
want to change. Then click Modify.
The Modify SNMPv3 Target Parameter Table Page is shown in
Figure 263 on page 737.
Figure 263 Modify SNMPv3 Target Parameters Table Page