Allied Telesis AT-S60 - Manual (Page 708)

Chapter 40: SNMPv3 Protocol
Section VI: Web Browser Management 708
3. In the SNMPv3 section of the page, click the circle next to Configure
View Table. Then click Configure.
4. The SNMPv3 View Table Page is shown in Figure 246 on page 705.
5. Click the circle next to the View Table entry that you want to delete.
Then click Remove.
A warning message is displayed. Click OK to remove the View
Table entry.
6. To save your changes, return to the General Tab and click Save
Changes.
Modifying a
View Table
Entry
To modify an entry in the SNMPv3 View Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
View Table. Then click Configure at the bottom of the page.
The SNMPv3 View Table Page is shown in Figure 246 on page 705.
4. To modify an SNMPv3 View Table entry, click the circle next to the
SNMPv3 View Table entry that you want to change. Then click
Modify.
The Modify SNMPv3 View Page is shown in Figure 248.
Figure 248 Modify SNMPv3 View Page