Allied Telesis AT-S60 - Manual (Page 797)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 797
Enabling TACACS+ or RADIUS
To configure the authentication protocols, perform the following
procedure:
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the Server-based Authentication Tab.
The Server-based Authentication Tab is shown in Figure 295.
Figure 295 Configuration System Page, Server-based Authentication Tab
3. To enable or disable the authentication feature on the switch, click
the Enable Server-based Authentication check box.
A check in the box indicates that this feature is disabled. The
default is disabled. No check in the box indicates the feature is
enabled.
4. To select an authentication protocol, click either TACACS+ or RADIUS
in the Authentication Method section of the tab. The default is
TACACS+.
Note
Only one authentication protocol can be active on the switch at a
time.