Allied Telesis AT-S60 - Manual (Page 714)

Chapter 40: SNMPv3 Protocol
Section VI: Web Browser Management 714
Deleting an
Access Table
Entry
To delete an entry in the SNMPv3 Access Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
Access Table. Then click Configure at the bottom of the page.
The SNMPv3 Access Table Page is shown in Figure 249 on page
710.
4. Display the Access Table entry that you want to delete.
Click Next or Previous to display an entry.
5. Click Remove.
A warning message is displayed. Click OK to remove the Access
Table entry.
6. To save your changes, return to the General Tab and click Save
Changes.
Modifying an
Access Table
Entry
To modify an entry in the SNMPv3 Access Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
Access Table. Then click Configure at the bottom of the page.
The SNMPv3 Access Table Page is shown in Figure 249 on page
710.
4. Display the Access Table entry that you want to change.
Click Next or Previous to display an entry.
5. Click Modify.