Allied Telesis AT-S60 - Manual (Page 709)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 709
5. In the Subtree Mask field, enter a subtree mask in hexidecimal format.
This is an optional parameter that is used to further refine the
value in the View Subtree parameter. This parameter is in binary
format.
The View Subtree parameter defines a MIB View and the Subtree
Mask further restricts a user’s view, for example, to a specific row
of the MIB tree. The value of the Subnet Mask parameter is
dependent on the subtree you select. See RFC 2575 for detailed
information about defining a subnet mask.
6. In the View Type field, enter one of the following view types:
Included
Enter this value to permit the View Name to see the subtree
specified above.
Excluded
Enter this value to not permit the View Name to see the subtree
specified above.
7. In the Storage Type field, enter a storage type for this table entry:
Volatile
Select this storage type if you do not want the ability to save an
entry in the Target Parameters Table to the configuration file.
After making changes to an Target Parameters Table entry with a
Volatile storage type, Save Changes does not appear on the
General Tab.
NonVolatile
Select this storage type if you want the ability to save an entry in
the View Table to the configuration file. After making changes to
a View Table entry with a NonVolatile storage type, Save Changes
appears on the General Tab.
Note
The Row Status parameter is a read-only field in the web interface.
The Active value indicates the SNMPv3 View Table entry takes effect
immediately.
8. Click Apply to update the SNMPv3 View Table.
9. To save your changes, return to the General Tab and click Save
Changes.