Allied Telesis AT-S60 - Manual (Page 428)

Chapter 18: Virtual LANs
Section IV: VLANs 428
Each menu selection is explained below.
1 - Add Ports to VLAN
To add ports to a VLAN, do the following:
a. Type 1 to select Add Ports to VLAN.
The following prompt is displayed:
Enter VLAN ID: [2 to 4094] ->
b. Enter the VID of the VLAN you want to change.
The following prompt is displayed:
Enter Tagged Port-list to add:
c. If you want to add one or more tagged ports to the VLAN, enter
them at this prompt. If you are not adding tagged ports, press
Return. For information on entering ports, refer to Specifying
Ports on page 34.
The following prompt is displayed:
Enter Untagged Port-list to add:
d. If you want to add one or more untagged ports to the VLAN, enter
them at this prompt. If you are not adding untagged ports, press
Return.
Changes are immediately activated on the VLAN.
Note
Untagged ports that are added to a VLAN are automatically
removed from their current untagged VLAN assignment. Adding a
tagged port to a VLAN does not effect the tagged port’s current
VLAN assignments.
e. Repeat this step to modify other VLANs.
f. After modifying a VLAN, type R until you return to the Main Menu.
Then type S to select Save Configuration Changes.
2 - Delete Ports from VLAN
To remove ports from a VLAN, do the following:
a. Type 2 to select Delete Ports from VLAN.
The following prompt is displayed:
Enter VLAN ID: [2 to 4094] ->
b. Enter the VID of the VLAN you want to change.
The following prompt is displayed:
Enter Tagged Port-list to delete: