Allied Telesis AT-S60 - Manual (Page 359)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 359
The Configure SNMPv3 Target Address Table Menu is shown in
Figure 114 on page 369.
Note
To display a Group Name and its associated parameters from the
Configure SNMPv3 SecurityToGroup Table Menu, type N to display
the Next Page and P to display the previous page.
3. To delete an SNMPv3 Target Address Table entry, type 2 to select
Delete SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Address Name:
4. Enter a Target Address Name.
The following prompt is displayed:
Do you want to delete this table entry? (Y/N):
[Yes/No]->
5. Enter Y to delete the SNMPv3 Target Address Table entry or N to save
it.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 Target
Address Table
Entry
This section describes how to modify parameters in an SNMPv3 Target
Address Table entry. See the following procedures:
❑ Modifying the Target IP Address on page 360
❑ Modifying the Target Address UDP Port on page 361
❑ Modifying the Target Address Timeout on page 362
❑ Modifying the Target Address Retries on page 363
❑ Modifying the Target Address Tag List on page 364
❑ Modifying the Target Parameters Field on page 365
❑ Modifying the Storage Type on page 366
Note
You cannot modify the Target Address Name parameter.