Allied Telesis AT-S60 - Manual (Page 809)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 809
5. After setting the parameters, click Apply.
Your changes are activated on the switch.
6. To save your changes, return to the General Tab and click Save
Changes.
Configuring
RADIUS
Accounting
This section describes how to configure the RADIUS accounting feature
from a web browser management session. For background information,
refer to Configuring RADIUS Accounting on page 568.
To enable or disable RADIUS accounting and its associated settings
access, perform the following procedure:
1. On the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
shown by default.
2. Select the Layer 1 option.
The Layer 1 Page is displayed with the Port Settings Tab shown by
default.
3. Select the 802.1x Port Access Tab.
The Configuration 802.1x Port Access Tab is displayed as shown in
Figure 301 on page 808.
4. Configure the parameters in the RADIUS Accounting section of the
tab. The parameters are described below:
Enable Accounting
Activates and deactivate RADIUS accounting on the switch. A check in
the box indicates the feature is activated. The default is Disabled.
Trigger Type
Specifies the action that causes the switch to send accounting
information to the RADIUS server. The choices are:
❑ Start_Stop: The switch sends accounting information whenever a
client logs on or logs off the network. This is the default.
❑ Stop: The switch sends accounting information only when a client
logs off.
Port Number
Specifies the UDP port for RADIUS accounting. The default is port
1813.
Type
Specifies the type of RADIUS accounting. The default is Network. This
value cannot be changed.