Allied Telesis AT-S60 - Manual (Page 331)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 331
Configure the values of the Read View Name, Write View Name, and
Notify View Name parameters with values previously configured with
the View Name parameter in the SNMPv3 View Table. This is the only
way to associate a Group Name with these Views. See Creating an
SNMPv3 View Table Entry on page 315.
See the following procedures:
❑ Modifying the Read View Name on page 331
❑ Modifying the Write View Name on page 334
❑ Modifying the Notify View Name on page 336
❑ Modifying the Storage Type on page 338
Modifying the Read View Name
To modify the Read View Name parameter in an SNMPv3 Access Table
entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in Creating an
SNMPv3 User Table Entry on page 305. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table Menu is shown in Figure 101 on
page 306.
2. From the Configure SNMPv3 Table Menu, type 4 to select Configure
SNMPv3 Access Table.
The Configure SNMPv3 Access Table is shown in Figure 106 on
page 325.
3. From the Configure SNMPv3 Access Table, type 3 to select Modify
SNMPv3 Table Entry.