Allied Telesis AT-S60 - Manual (Page 545)

AT-S60 Management Software User’s Guide
Section V: Security Features 545
Configuring TACACS+
To configure TACACS+, perform the following procedure:
1. From the Main Menu, type 6 to select Security Menu.
The Security Menu is shown in Figure 151 on page 473.
2. From the Security Menu, select Server Based Authentication.
The Authentication Menu is shown in Figure 173 on page 544.
3. Type 3 to select TACACS+ Configuration.
The TACACS+ Client Configuration Menu is shown in Figure 174.
Figure 174 TACACS+ Client Configuration Menu
4. Configure the settings as needed. The settings are described below:
1 - TAC Server 1
2 - TAC Server 2
3 - TAC Server 3
Use these parameters to specify the IP addresses of up to three
network servers containing TACACS+ server software. After you
have entered an IP address, the following prompt is displayed:
Use per-server secret [Y/N] ->
If you are specifying more than one TACACS+ server and if all of
the servers use the same encryption secret, you can answer No to
this prompt and enter the encryption secret by typing 5 to select
TAC Global Secret parameter.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:36 01-Jan-2004
TACACS+ Client Configuration
1 - TAC Server 1 .................. 0.0.0.0
2 - TAC Server 2 .................. 0.0.0.0
3 - TAC Server 3 .................. 0.0.0.0
4 - TAC Server Order .............. 1 2 3
5 - TAC Global Secret .............
6 - TAC Timeout ................... 30 seconds
R - Return to Previous Menu
Enter your selection?