Allied Telesis AT-S60 - Manual (Page 374)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Protocol 374
Note
You cannot modify an entry in the SNMPv3 Target Parameter Table
that contains a value of “default” in the Target Parameters Name
field.
Modifying the Security Name (User Name)
In the AT-S60 implementation of the SNMPv3 protocol, the Security
Name and the User Name parameters are equivalent. In the SNMPv3
Target Parameters Table Menu, the Security Name and the User Name
parameters are used interchangeably.
When you modify the Security Name parameter, you must use a value
that you configured with the User Name parameter in the Configure
SNMPv3 User Table Menu. If you do not use a value configured with the
User Name parameter, messages are not sent on behalf of this User
Name. See Creating an SNMPv3 User Table Entry on page 305.
To modify the Security Name parameter in an SNMPv3 Target Parameter
Table entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in Creating an
SNMPv3 User Table Entry on page 305. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table Menu is shown in Figure 101 on
page 306.
2. From the Configure SNMPv3 Table Menu, type 8 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Parameters Table Menu is shown in
Figure 114 on page 369.
3. From the Configure SNMPv3 Target Parameters Table Menu, type 3 to
select Modify SNMPv3 Table Entry.