Allied Telesis AT-S60 - Manual (Page 733)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 733
Configuring the SNMPv3 Target Parameters Table
You can create, delete, and modify an SNMPv3 Target Parameters Table
entry. See the following procedures:
❑ Creating a Target Address Table Entry on page 727
❑ Deleting a Target Address Table Entry on page 730
❑ Modifying Target Address Table Entry on page 730
For reference information about the SNMPv3 Target Parameters Table,
see Configuring the SNMPv3 Target Parameters Table on page 733.
Creating a
Target
Parameters
Table Entry
To create an entry in the SNMPv3 Target Parameters Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
Target Parameters Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Parameters Table Page is shown in Figure 261.
Figure 261 SNMPv3 Target Parameters Table Page