Allied Telesis AT-S60 - Manual (Page 710)

Chapter 40: SNMPv3 Protocol
Section VI: Web Browser Management 710
Configuring the SNMPv3 Access Table
You can create, delete, and modify an SNMPv3 Access Table entry. See
the following procedures:
❑ Creating an Access Table on page 710
❑ Deleting an Access Table Entry on page 714
❑ Modifying an Access Table Entry on page 714
For reference information about the SNMPv3 Access Table, see
Configuring the SNMPv3 Access Table on page 710.
Creating an
Access Table
To create an entry in the SNMPv3 Access Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
Access Table. Then click Configure at the bottom of the page.
The SNMPv3 Access Table Page is shown in Figure 249.
Figure 249 SNMPv3 Access Table Page
4. To create an SNMPv3 Access Table entry, click Add.