Creating an snmpv3 community table entry – Allied Telesis AT-S60 User Manual

Page 382

Chapter 17: SNMPv3 Configuration

Section III: SNMPv3 Protocol

382

For each SNMPv3 Community Table entry, you can configure the
following parameters:

❑ Community Index

❑ Community Name

❑ Security Name

❑ Transport Tag

❑ Storage Type

In addition, you can display the entries configured with the Configure
SNMPv1 & SNMPv2c Community Menu in the Configure SNMPv3
Community Table Menu. However, you cannot modify an SNMPv1 &
SNMPv2c Community Table entry with the Configure SNMPv3
Community Table Menu.

There are three functions you can perform with the Configure SNMPv3
Target Parameters Table Menu.

❑ Creating an SNMPv3 Community Table Entry on page 382

❑ Deleting an SNMPv3 Community Table Entry on page 385

❑ Modifying an SNMPv3 Community Table Entry on page 386

Creating an

SNMPv3

Community

Table Entry

To create an entry in the Configure SNMPv3 Community Table Menu,
perform the following procedure.

1. Follow steps 1 through 5 in the procedure described in Creating an

SNMPv3 User Table Entry on page 305. Or, from the Main Menu type
5->1->1->8->5.

The Configure SNMPv3 Table Menu is displayed Figure 101 on
page 306.