Allied Telesis AT-S60 - Manual (Page 332)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Protocol 332
The Modify SNMPv3 Access Table is shown in Figure 107.
Figure 107 Modify SNMPv3 Access Table Menu
4. To modify the Read View Name parameter, type 1 to select Set Read
View Name.
The following prompt is displayed:
Enter Group Name:
5. Enter a Group Name that was previously configured.
The following prompt is displayed:
Enter Security Model [1-v1, 2-v2c, 3-v3]:
6. Enter the Security Model configured for this Group Name. You cannot
change the value of the Security Model parameter.
Select one of the following SNMP protocols:
1-v1
Select this value to associate the Group Name with the SNMPv1
protocol.
2-v2c
Select this value to associate the Group Name with the SNMPv2c
protocol.
3-v3
Select this value to associate the Group Name with the SNMPv3
protocol.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:33 15-Jan-2004
Modify SNMPv3 Access Table
Group Name .... sales Security Model . v3
Context Prefix. Security Level . AuthNoPriv
Read View...... systemmanagers Context Match .. Exact
Write View .... salespeople Storage Type ... Volatile
Notify View ... salespeople Row Status ..... Active
1 - Set Read View Name
2 - Set Write View Name
3 - Set Notify View Name
4 - Set Storage Type
U - Update Display
R - Return to Previous Menu
Enter your selection?