Allied Telesis AT-S60 - Manual (Page 74)

Chapter 3: Basic Switch Parameters
Section I: Basic Features 74
Configuring the Console Startup Mode
You can configure the AT-S60 software to display either the Main Menu
or the command line interface prompt (#) when you start a local or
Telnet management session. The default is the Main Menu.
To change the console startup mode, perform the following procedure:
1. From the Main Menu, type 5 to select the System Menu.
The System Menu is shown in Figure 5 on page 51.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown in Figure 11 on page 59.
3. From the Configure System Menu, type 1 to select Configure System
Software.
The Configure System Software Menu is shown in Figure 12 on
page 60.
4. Type 4 to select Console Startup Mode to toggle between the
following values.
❑ Select Menu to start a management session with the Main Menu
when you log in. Menu is the default.
❑ Select CLI to start a management session with the Command Line
Interface when you log in.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Your changes to the console startup mode take effect the next
time you start a management session.