Allied Telesis AT-S60 - Manual (Page 427)

AT-S60 Management Software User’s Guide
Section IV: VLANs 427
Modifying a VLAN
The section contains the procedure for adding or deleting ports from a
tagged or port-based VLAN.
To modify a VLAN, perform the following procedure:
1. From the Configure Port Based VLAN menu, type 3 to select Modify
Port Based VLAN.
The Modify Port Based VLAN menu is shown in Figure 135.
Figure 135 Modify Port Based VLAN Menu
The top portion of the menu displays the current VLANs on the
switch. For an explanation of the columns, refer to the procedure
Displaying VLANs on page 418.
Note
You cannot add or remove ports from a dynamic GVRP VLAN and
you cannot remove a dynamic GVRP port from a port-based or
tagged VLAN. For information on GVRP, refer to Chapter 20, GARP
VLAN Registration Protocol on page 444.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:33 01-Jan-2004
Modify Port Based VLAN
VID VLAN Name VLAN Type Protocol Tagged /Untagged Ports
----------------------------------------------------------------------
1
Default_VLAN Port Based U: 11.1-8, 12.8
T: 5.1, 6.3
12 Sales Port Based U: 1.1-8, 2.1-8, 3.4-8
1 - Add Ports to VLAN
2 - Delete Ports from VLAN
3 - Set Ports to VLAN
4 - Clear Ports from VLAN
5 - Change GARP VLAN
U - Update display
R - Return to Previous Menu
Enter your selection?