Allied Telesis AT-S60 - Manual (Page 569)

AT-S60 Management Software User’s Guide
Section V: Security Features 569
5. Select a status for the RADIUS Accounting feature.
Choose from the following options:
E - Enables RADIUS accounting on the switch.
D - Disables RADIUS accounting on the switch. The default is Disable.
6. To specify the UDP port for RADIUS accounting, type 2 to select
Radius Accounting Port.
The following prompt is displayed:
Enter new value: [1 to 65535] -> 1813
7. Enter a new value for the UDP for RADIUS accounting. The default is
port 1813.
Note
The type of RADIUS accounting is specified by option 3 - RADIUS
Accounting Type parameter. This is a read-only parameter. The
default value is Network.
8. To specify the action that causes the switch to sending accounting
information to the RADIUS server, type 4 to select Radius Accounting
Trigger Type.
The following prompt is displayed:
RADIUS Accounting Trigger (1-Start Stop 2-Stop
Only)-> [1 to 2]-> 1
9. Select the action that causes the switch to send accounting
information to the RADIUS server.
Choose from the following selections:
1 - Select 1 to choose Start Stop. With this selection, the switch
sends accounting information whenever a client logs on or logs
off the network. This is the default.
2 - Select 2 to choose Stop Only. With this selection, the switch
sends accounting information only when a client logs off.
10. To control whether or not the switch sends interim accounting
updates to the RADIUS server, type 5 to select Radius Accounting
Update Status.
The following prompt is displayed:
RADIUS Accounting Update (E-Enable, D-Disable)->
11. Enter the RADIUS Accounting update status.