Allied Telesis AT-S60 - Manual (Page 307)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 307
The Configure SNMPv3 User Table Menu is shown in Figure 102.
Figure 102 Configure SNMPv3 User Table Menu
7. To create a new user table, type 1 to select Create SNMPv3 Table
Entry.
The following prompt is displayed:
Enter User (Security) Name:
8. Enter a descriptive name of the user.
You can enter a name that consists of up to 32-alphanumeric
characters.
The following prompt is displayed:
Enter Authentication Protocol [M-MD5, S-SHA,
N-None]:
9. Enter one of the following:
M-MD5
This value represents the MD5 authentication protocol. With this
selection, users are authenticated with the MD5 authentication
protocol after a message is received. This algorithm generates the
message digest. The user is authenticated when the
authentication protocol checks the message digest. With the MD5
selection, you can configure a Privacy Protocol.
S-SHA
This value represents the SHA authentication protocol. With this
selection, users are authenticated with the SHA authentication
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:33 15-Jan-2004
Configure SNMPv3 User Table
Engine ID ................. 80:00:00:CF:03:00:30:84:FD:57:DA
User Name ................. jenny
Authentication Protocol ... MD5
Privacy Protocol .......... DES
Storage Type .............. NonVolatile
Row Status ................ Active
1 - Create SNMPv3 Table Entry
2 - Delete SNMPv3 Table Entry
3 - Modify SNMPv3 Table Entry
U - Update Display
R - Return to Previous Menu
Enter your selection?