Allied Telesis AT-S60 - Manual (Page 596)

Chapter 30: Basic Switch Parameters
Section VI: Web Browser Management 596
The SNMP Tab is shown in Figure 195.
Figure 195 Configuration System Page, SNMP Tab
3. To enable SNMP Access for the SNMPv1 and SNMPv2c protocols, click
the box next to Enable SNMP Access.
Use this parameter to enable the switch to be remotely managed
with an SNMP application program.
Note
If the check box in the Enable SNMP Access box is empty, the switch
cannot be managed through SNMP. This is the default.
4. To enable authentication failure traps to be sent, click the box next to
Enable Authentication Failure Trap.
When this field is selected and the switch receives an
unauthenticated request, an authentication failure trap is sent to
the trap receivers configured on the switch.
5. Click Apply to update the SNMP Tab.