Allied Telesis AT-S60 - Manual (Page 93)

AT-S60 Management Software User’s Guide
Section I: Basic Features 93
The Modify SNMPv1 and SNMPv2c Community Menu is shown in
Figure 24.
Figure 24 Modify SNMPv1 & SNMPv2c Community Menu
7. To add SNMP manager and Trap Receiver IP addresses, type 1 to
select Add Attributes to Community.
For each community, you can add up to eight IP addresses for
SNMP Managers and up to eight Trap Receiver IP addresses.
The following prompt is displayed:
Enter SNMP Community Name:
8. Enter an SNMP community name from the list at the top of the menu.
SNMP community names are case sensitive.
The following prompt is displayed:
Enter SNMP Manager IP Addr:
9. Enter an IP address to permit the SNMP manager to access the switch.
Or, to skip this prompt, press Return.
Use the following format for an IP address:
XXX.XXX.XXX.XXX
The following prompt is displayed:
Enter Trap Receiver IP Addr:
10. Enter an IP address to send trap messages. Or, to skip this prompt,
press Return.
Use the following format for an IP address:
XXX.XXX.XXX.XXX
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:33 15-Jan-2004
Modify SNMPv1 & SNMPv2c Community
Community Name Access Mode Status OpenAcc Manager IP Addr Trap Receiver IP
====================================================================================
142alliedtelesyn Read|Write Enabled No 147.35.18.85 1.1.1.1
2.2.2.2 2.2.2.2
sunnyvalepub23 Read Only Enabled No 147.35.18.86 158.12.18.1
158.12.18.20 158.10.10.16
1 - Add Attributes to Community
2 - Delete Attributes from Community
3 - Set Community Access Mode
4 - Set Community Status
5 - Set Community Open Access
U - Update Display
R - Return to Previous Menu