Allied Telesis AT-S60 - Manual (Page 298)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Protocol 298
To determine the destination of the message, you configure the IP
address of the host. This configuration is similar to the SNMPv1 and
SNMPv2c configuration.
The SNMP security information consists of information about the
following:
❑ User
❑ View of the MIB Tree
❑ Security Level
❑ Security Model
❑ Authentication Level
❑ Privacy Protocol
❑ Group
To configure the SNMP security information, you associate a user and its
related information—View, Security Level, Security Model,
Authentication Level, Privacy Protocol and Group—with the type of
message and the host IP address.
SNMPv3 Tables The SNMPv3 configuration is neatly divided into configuring SNMPv3
user information and configuring the message notification. You must
configure all seven tables to successfully configure the SNMPv3
protocol. Use the following tables for user configuration:
❑ Configure SNMPv3 User Table
❑ Configure SNMPv3 View Table
❑ Configure SNMPv3 Access Table
❑ Configure SNMPv3 SecurityToGroup Table