Allied Telesis AT-S60 - Manual (Page 150)

Chapter 9: Port Mirroring
Section I: Basic Features 150
Disabling a Destination Port Mirror
Use this procedure to prevent traffic from the source mirror port from
being mirrored to the destination port. You may want to use this
procedure to temporarily stop mirroring the source traffic while
reserving the destination port for mirroring.
To disable a port mirror, perform the following procedure:
1. From the Main Menu, type 1 to select Port Menu.
The Port Menu is shown in Figure 26 on page 102.
2. From the Port Menu, type 5 to select Port Mirroring.
The Port Mirroring menu is shown in Figure 39 on page 144.
3. Type 5 to select Disable Mirror.
The following prompt is displayed.
Enter Destination Port [port-list, all]:
4. Enter the mirror port that you want to disable and press Return.
port-list
For information about how to specify ports, see Specifying Ports
on page 34.
all
Use this selection to disable all the mirror ports listed on the Port
Mirroring Menu.
At the top of the Port Mirroring menu, the Status column changes
to Disabled.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
The port mirror is now disabled.