Allied Telesis AT-S60 - Manual (Page 422)

Chapter 18: Virtual LANs
Section IV: VLANs 422
3. From the Configure VLAN menu, type 4 to select Configure Port-
Based VLAN.
The Configure Port Based VLAN Menu is shown in Figure 134.
Figure 134 Configure Port Based VLAN Menu
The top portion of the menu displays the current VLANs on the
switch. For an explanation of the columns, refer to Displaying VLANs
on page 418. If you have not created any VLANs, this menu contains
only the Default_VLAN.
4. Type 1 to select Create Port Based VLAN.
The following prompt is displayed:
Enter VLAN Name:
5. Enter a name for the new VLAN.
The name can be from one to nineteen characters in length. The
name should reflect the function of the nodes that are part of the
VLAN (for example, Sales or Accounting). The name cannot contain
spaces or special characters, such as asterisks (*) or exclamation
points (!).
If the VLAN is unique in your network, then the name should be
unique as well. If the VLAN is to be part of a larger VLAN that spans
multiple switches, then the name for the VLAN should be the same on
each switch where nodes of the VLAN are connected.
Note
You must assign a name to a VLAN.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
High School Switch 142
User: Manager 00:14:33 01-Jan-2004
Configure Port-Based VLAN
VIDVLAN Name VLAN Type Protocol Tagged(T)/Untagged(U) Ports
----------------------------------------------------------------------
1
Default_VLAN Port Based U: 11.1-8, 12.8
T: 5.1, 6.3
12 Sales Port Based U: 1.1-8, 2.1-8, 3.4-8, 4.1-2, 7.1-2
T: 5.1, 6.3
20 Production Port Based U: 3.1-3, 4.3-8, 5.2-8, 6.1-8
1 - Create Port Based VLAN
2 - Delete
Port Based VLAN
3 - Modify Port Based VLAN
U - Update display
R - Return to Previous Menu
Enter your selection?