Allied Telesis AT-S60 - Manual (Page 329)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 329
Deleting an
SNMPv3 Access
Table Entry
You may want to delete an entry from the SNMPv3 Access Table. After
you delete an SNMPv3 Access Table, there is no way to undelete, or
recover, it.
To delete an entry in the SNMPv3 Access Table, perform the following
procedure:
1. Follow steps 1 through 5 in the procedure described in Creating an
SNMPv3 User Table Entry on page 305. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table Menu is shown in Figure 101 on
page 306.
2. From the Configure SNMPv3 Table Menu, type 4 to select Configure
SNMPv3 Access Table.
The SNMPv3 Access Table is shown in Figure 106 on page 325.
Note
To display a particular Group Name and its associated parameters
from the Configure SNMPv3 Access Table Menu, type N to display
the Next Page and P to display the previous page.
3. From the SNMPv3 Access Table, type 2 to select Delete SNMPv3 Table
Entry.
The following prompt is displayed:
Enter Group Name:
4. Enter the Group Name that you want to delete.
The following prompt is displayed:
Enter Security Model [1-v1, 2-v2c, 3-v3]:
5. Enter the Security Model of this Group Name.
Select one of the following security levels:
1-v1
Select this value to associate the Group Name with the SNMPv1
protocol.
2-v2c
Select this value to associate the Group Name with the SNMPv2c
protocol.
3-v3
Select this value to associate the Group Name with the SNMPv3
protocol. The following prompt is displayed:
Enter the Security Level [N-NoAuthNoPriv,
A-AuthNoPriv, P-AuthPriv]: