Allied Telesis AT-S60 - Manual (Page 681)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 681
Configuring and Modifying MSTP
The procedures for configuring and modifying MSTP are provided in this
section. See the following procedures:
❑ Configuring MSTP Parameters on page 681
❑ Configuring the CIST Priority on page 684
❑ Creating, Deleting, or Modifying MSTI IDs on page 685
❑ Adding, Removing, or Modifying VLAN Associations to MSTIs on
page 687
❑ Configuring MSTP Port Parameters on page 689
Note
MSTP must be selected as the active spanning tree protocol on the
switch before you can configure it. For instructions on selecting the
active spanning tree, refer to Enabling STP, RSTP, or MSTP on page
670.
Note
When MSTP is enabled, the GVRP Tab is not shown on the
Configuration or Monitoring Layer 2 Page.
Configuring
MSTP
Parameters
To configure MSTP parameters, perform the following procedure:
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default in Figure 192 on page 584.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 Page is displayed with the MAC Address Tab selected
by default in Figure 212 on page 634.
3. Select the Spanning Tree Tab.
The Spanning Tree Tab is shown in Figure 230 on page 670.
4. Click on MSTP as the active protocol version.
5. Click Apply.
The following message is displayed:
The switch will be rebooted for this change. Do you
want to continue?
6. Click Okay.
7. Click Configure.