Allied Telesis AT-S60 - Manual (Page 282)

Chapter 16: Multiple Spanning Tree
Section II: Advanced Features 282
5. Enter the new MSTP ID.
The MSTI IDs range is from 1 to 15. You can specify only one MSTI
ID at a time.
The following prompt is displayed:
Success...Do you want to associate VLANs with this
MSTI ID: [Yes/No] ->
6. If you want to associate VLANs to the MSTI now, type Y for yes. If you
want to do it later, type N for no.
To add or remove VLANs from an existing MSTI, go to Associating
VLANs to MSTI IDs on page 283.
If you respond with yes, the following prompt is displayed:
Enter the list of VLANs:
7. Enter the VIDs of the VLANs that you want to associate with the MSTI
ID.
You can specify more than one VLAN at a time (for example,
4,6,11) To view VIDs, refer to Displaying VLANs on page 418.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an MSTI ID
To delete an MSTI ID, do the following:
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu is shown in Figure 91 on page 275.
2. From the Spanning Tree Menu, type 5 to select MSTP Configuration.
The MSTP Menu is shown in Figure 92 on page 277.
3. From the MSTI Menu, type 2 to select Delete MSTI.
The following prompt is displayed:
Enter the MSTI ID to be deleted: [1 to 15] ->
4. Enter the MSTP IDs that you want to delete.
The range is 1 to 15. (You cannot delete CIST, which has a value
of 0.)
All VLANs associated with a deleted MSTP ID are returned to CIST.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.