Allied Telesis AT-S60 - Manual (Page 349)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 349
The Configure SNMPv3 Notify Table Menu is shown in Figure 110.
Figure 110 Configure SNMPv3 Notify Table Menu
3. To create an entry in the table, type 1 to select Create SNMPv3 Table
Entry.
The following prompt is displayed:
Enter Notify Name:
4. Enter the name associated with this trap message.
Enter a name of up to 32-alphanumeric characters. For example,
you might want to define a trap message for hardware
engineering and enter a value of “hardwareengineeringtrap” for
the Notify Name.
The following prompt is displayed:
Enter Notify Tag:
5. Enter the name of the Notify Tag.
Enter a name of up to 32 alphanumeric characters. The following
prompt is displayed:
Enter Notify Type [T-Trap, I-Inform]:
6. Enter one of the following message types:
T-Trap
Indicates this notify table is used to send traps. With this message
type, the switch does not expects a response from the
authoritative entity.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Marketing Switch 17
User: Manager 00:14:33 15-Jan-2004
Configure SNMPv3 Notify Table
Notify Name ...................... hardwareengineeringTrap
Notify Tag ....................... hardwareengineeringtag
Notify Type ...................... Trap
Storage Type ..................... NonVolatile
Row Status ....................... Active
1 - Create SNMPv3 Table Entry
2 - Delete SNMPv3 Table Entry
3 - Modify SNMPv3 Table Entry
U - Update Display
R - Return to Previous Menu
Enter your selection?