Allied Telesis AT-S60 - Manual (Page 288)

Chapter 16: Multiple Spanning Tree
Section II: Advanced Features 288
You can enter more than one VLAN at a time (for example, 2,4,7)
(To view VIDs, refer to Displaying VLANs on page 418.)
The VLANs already associated with the MSTI ID are removed when
the new VLANs are added. The removed VLANs are returned to
CIST.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Configuring
MSTP Port
Settings
To configure a port’s MSTP parameters, perform the following
procedure:
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu is shown in Figure 91 on page 275.
2. From the Spanning Tree Menu, type 5 to select MSTP Configuration.
The MSTP Menu is shown in Figure 92 on page 277.
3. From the MSTP Menu, type P to select MSTP Port Parameters.
The MSTP Port Parameters menu is shown in Figure 96.
Figure 96 MSTP Port Parameters Menu
4. Type 1 to select Configure MSTP Port Settings.
The following prompt is displayed:
Enter port-list:
5. Enter the port to configure. For instructions on how to specify port
numbers, refer to Specifying Ports on page 34.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:33 15-Jan-2004
MSTP Port Parameters
1 - Configure MSTP Port Settings
2 - Display MSTP Port Configuration
3 - Display MSTP Port State
R - Return to Previous Menu
Enter your selection?