Allied Telesis AT-S60 - Manual (Page 310)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Protocol 310
The following prompt is displayed:
Enter User (Security) Name:
4. Enter the User Name of the User Table entry you want to delete.
The following prompt is displayed:
Do you want to delete this table entry? (Y/N):
[Yes/No]->
5. Enter Y to delete the user or N to save the user.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 User
Table Entry
This section describes how to modify parameters in an SNMPv3 Notify
Table entry. See the following procedures:
❑ Modifying the Authentication Protocol and Password on page
310
❑ Modifying the Privacy Protocol and Password on page 312
❑ Modifying the Storage Type on page 314
Modifying the Authentication Protocol and Password
To modify the Authentication Protocol and Password in an SNMPv3 User
Table entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in Configuring
the SNMPv3 User Table on page 305. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 User Table Menu is shown in Figure 101
2. From the Configure SNMPv3 Table Menu, type 2 to select Configure
SNMPv3 User Table.
The SNMPv3 User Table is shown in Figure 102.
3. From the SNMPv3 User Table, type 3 to select Modify SNMPv3 Table
Entry.