Allied Telesis AT-S60 - Manual (Page 300)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Protocol 300
You start the message notification configuration by defining the type of
message you want to send with the SNMPv3 Notify Table. Then you
define a IP address that is used for notification in the Configure SNMPv3
Target Address Table. This is the IP address of the SNMPv3 manager.
Finally, you associate the trap information with a user by configuring the
Configure SNMPv3 Target Parameters Table.
See Figure 100 for an illustration of how the message notification tables
are linked.
Figure 100 SNMPv3 Message Notification Process
For a more detailed description of the SNMPv3 Tables, see the following
subsections:
❑ SNMPv3 User Table on page 301
❑ SNMPv3 View Table on page 301
❑ SNMPv3 SecurityToGroup Table on page 302
❑ SNMPv3 Notify Table on page 302
❑ SNMPv3 Target Address Table on page 302
SNMPv3 Notify Table
SNMPv3 Target Address Table
SNMPv3 Target Parameter Table
SNMPv3 User Table
SNMPv3 View Table
SNMPv3 Access Table
SNMPv3 SecurityToGroup Table
Linked by View Name
Linked by Group Name
Linked by User Name
or Security Name
Linked by
Security Name
and
Security Model
Linked by Notify Tag
Linked by Target Parameter Name