Allied Telesis AT-S60 - Manual (Page 599)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 599
Access Mode
Click Read Only to allow read access to the SNMP community. To
allow read-write access to the SNMP community, click Read-Write.
Open Access
Click this option to allow any SNMP manager to access the switch.
Manager IP Address1 through Manager IP Address 8
Enter an IP Address of a switch that is permitted SNMP manager
access to the current switch. You can enter up to 8 Manager IP
Addresses.
Trap Receiver IP Address 1 through Trap Receiver IP Address 8
Use the above selections to specify the IP addresses of up to 8 trap
receivers on your network that can receive traps from the switch.
9. Click Apply to update the SNMP Page.
10. To save your changes, return to the General Tab and click Save
Changes.
Modifying an
SNMPv1 and
SNMPv2c
Community
To modify an SNMPv1 and SNMPv2c community, perform the following
procedure:
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. To configure SNMPv1 and SNMPv2 communities, select Configure in
the SNMPv1 & SNMPv2c section of the SNMP Tab.
The SNMPv1 & SNMPv2c Communities Page is shown in Figure
196 on page 597.
4. To change an SNMP community, click the circle next to the
community name. Then click Modify.
The Modify SNMPv1 & SNMPv2c Community Page is shown in
Figure 198.