Allied Telesis AT-S60 - Manual (Page 311)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 311
The Modify SNMPv3 User Table is shown in Figure 103.
Figure 103 Modify SNMPv3 User Table Menu
4. To change the authentication protocol and password, type 1 to select
Set Authentication Protocol & Password.
The following prompt is displayed:
Enter User Name:
5. Enter the User Name of the User Table you want to modify.
The following prompt is displayed:
Enter Authentication Protocol [M-MD5, S-SHA,
N-None]:
6. Enter one of the following:
M-MD5
This value represents the MD5 authentication protocol. With this
selection, users are authenticated with the MD5 authentication
protocol after a message is received. This algorithm generates the
message digest. The user is authenticated when the
authentication protocol checks the message digest. With the MD5
selection, you can configure a Privacy Protocol.
S-SHA
This value represents the SHA authentication protocol. With this
selection, users are authenticated with the SHA authentication
protocol after a message is received. This algorithm generates the
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:33 15-Jan-2004
Modify SNMPv3 User Table
Engine ID ................. 80:00:00:CF:03:00:30:84:FD:57:DA
User Name ................. wilson
Authentication Protocol ... SHA
Privacy Protocol .......... DES
Storage Type .............. NonVolatile
Row Status ................ Active
1 - Set Authentication Protocol & Password
2 - Set Privacy Protocol & Password
3 - Set Storage Type
U - Update Display
R - Return to Previous Menu
Enter your selection?