Allied Telesis AT-S60 - Manual (Page 731)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 731
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
Target Address Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Address Table Page is shown in Figure 258 on
page 728.
4. Display the Target Address Table entry that you want to change.
Click Next or Previous to display an entry.
5. Click Modify.
The Modify SNMPv3 Target Address Table Page is shown Figure
260.
Figure 260 Modify SNMPv3 Target Address Table Page
6. In the IP Address field, enter the IP address of the host.
Use the following format for an IP address:
XXX.XXX.XXX.XXX
7. In the UDP Port Number field, enter a UDP port number.
You can enter a UDP port in the range of 0 to 65,535. The default
UDP port is 162.
8. In the Timeout field, enter a timeout value in milliseconds.