Allied Telesis AT-S60 - Manual (Page 672)

Chapter 39: STP, RSTP, and MSTP
Section VI: Web Browser Management 672
Configuring and Modifying STP
To configure and modify STP, perform the following procedure:
Caution
The bridge provides default STP parameters that are adequate for
most networks. Changing the STP parameters without prior
experience and an understanding of how STP works may have a
negative effect on your network. Consult the IEEE 802.1d standard
before changing any of the STP parameters.
1. Follow the steps in the procedure described in Enabling STP, RSTP, or
MSTP on page 670, then select STP as your active protocol version.
2. On the Spanning Tree Tab, click Configure.
An expanded Spanning Tree Tab is shown in Figure 231 on page
673.