Allied Telesis AT-S60 - Manual (Page 691)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 691
Displaying STP, RSTP, or MSTP Settings
To display spanning tree parameter settings, perform the following
procedure:
1. From the Home Page, select Monitoring.
The Monitoring System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 592.
2. Select the Layer 2 option.
The Monitoring Layer 2 Page is displayed with the MAC Address
Tab selected by default, as shown Figure 212 on page 634.
3. Select the Spanning Tree Tab.
The Monitoring Spanning Tree Tab is shown in Figure 240. This
tab displays whether spanning tree is enabled or disabled and
which spanning tree protocol is active.
Figure 239 Monitoring Layer 2 Page, Spanning Tree Tab
4. To view the current settings for the active spanning tree protocol,
click View.