Allied Telesis AT-S60 - Manual (Page 740)

Chapter 40: SNMPv3 Protocol
Section VI: Web Browser Management 740
Configuring the SNMPv3 Community Table
You can create, delete, and modify an SNMPv3 Community Table entry.
See the following procedures:
❑ Creating an SNMPv3 Community Table Entry on page 740
❑ Deleting an SNMPv3 Community Table Entry on page 743
❑ Modifying an SNMPv3 Community Table Entry on page 743
For reference information about the SNMPv3 Community Table, see
Configuring the SNMPv3 Community Table on page 740.
Note
Use the SNMPv3 Community Table only if you are configuring the
SNMPv3 protocol with an SNMPv1 or an SNMPv2c implementation.
Allied Telesyn does not recommend this configuration.
Creating an
SNMPv3
Community
Table Entry
To create an SNMPv3 Community Table entry, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
Community Table. Then click Configure at the bottom of the page.
The SNMPv3 Community Table Page is shown in Figure 264 on
page 741.