Allied Telesis AT-S60 - Manual (Page 319)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 319
The following prompt is displayed:
Enter View Subtree (OID format/Text Name):
5. Enter the subtree for this view.
Do you want to delete this table entry? (Y/N):
[Yes/No]->
6. Enter Y to delete the view or N to save the view.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 View
Table Entry
This section describes how to modify parameters in an SNMPv3 Notify
Table entry. See the following procedures:
❑ Modifying a Subtree Mask on page 319
❑ Modifying a View Type on page 321
❑ Modifying a Storage Type on page 322
Modifying a Subtree Mask
To modify the Subtree Mask parameter in an SNMPv3 View Table entry,
perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in Creating an
SNMPv3 User Table Entry on page 305. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table Menu is shown in Figure 101 on
page 306.
2. From the Configure SNMPv3 Table Menu, type 3 to select Configure
SNMPv3 View Table.
The Configure SNMPv3 View Table Menu is shown in Figure 104
on page 316.
3. From the Configure SNMPv3 View Table Menu, type 3 to select
Modify SNMPv3 Table Entry.