Allied Telesis AT-S60 - Manual (Page 375)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 375
The Modify SNMPv3 Target Parameters Table Menu is shown in
Figure 115.
Figure 115 Modify SNMPv3 Target Parameters Table Menu
4. To change the Security Name parameter, type 1 to select Set Security
Name.
The following prompt is displayed:
Enter Target Parameters Name:
5. Enter a previously configured Target Parameters Name.
Enter a value of up to 32-alphanumeric characters.
The following prompt is displayed:
Enter User (Security) Name:
6. Enter a User Name.
Enter a value that you previously configured with the Configure
SNMPv3 User Table Menu. You can enter a value of up to 32-
alphanumeric characters.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Marketing Switch 17
User: Manager 00:14:33 15-Jan-2004
Modify SNMPv3 Target Parameters Table
Target Parameters Name ... host27
Message Processing Model . v3
Security Model............ v3
Security Name ............ hoa
Security Level ........... AuthNoPriv
Storage Type ............. NonVolatile
Row Status ............... Active
1 - Set Security Name
2 - Set Security Model
3 - Set Security Level
4 - Set Message Processing Model
5 - Set Storage Type
U - Update Display
R - Return to Previous Menu
Enter your selection?