Allied Telesis AT-S60 - Manual (Page 557)

AT-S60 Management Software User’s Guide
Section V: Security Features 557
Enabling and Disabling Port-based Access Control
To globally enable or disable port-based access control, perform the
following procedure.
Note
Enabling or disabling port-based access control can only be
performed in a local management session.
Note
Before activating this feature, you must have the RADIUS EAP
specified and enabled as the authentication method. This is
discussed in Enabling TACACS+ or RADIUS on page 544.
1. From the Main Menu, type 6 to select Security Menu.
The Security Menu is shown in Figure 151 on page 473.
2. From the Security Menu, select Port Access Control.
The Port Access Control Menu is shown in Figure 180.
Figure 180 Port Access Control Menu
3. Type 1 to select Port Access Control. The following prompt is
displayed:
Port Access Control (E-Enable, D-Disable) ->
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Production Switch 142
User: Manager 00:14:33 25-Jan-2004
Port Access Control
1 - Port Access Control ............. Enabled
2 - Authentication Method ........... RADIUS EAP
3 - Configure Port Access Role
4 - Configure Authenticator
5 - Configure Supplicant
6 - Display Port Access Status
R - Return to Previous Menu
Enter your selection?