Allied Telesis AT-S60 - Manual (Page 622)

Chapter 33: Port Parameters
Section VI: Web Browser Management 622
Caution
Use caution when you update the port that is connected to your
management workstation and is communicating with the switch.
When you make changes to this port, you could inadvertently lose
your management session.
4. Click Modify.
The Port Configuration Page is shown in Figure 208.
Figure 208 Port Configuration Page
Note
Clicking the Defaults button returns the port settings to the default
values which are listed in Appendix A, AT-S60 Default Settings on
page 820.
5. Adjust the port parameters as desired.
The parameters are described below.
Port Name:
This is the name of the port or ports you selected for configuration
in Step 5. If you selected one port, you can change the port name
in this field. However, if you selected more than one port, you
cannot change this value. The port(s) you selected appear at the
top of the page. In Figure 208, the port 2.1 was selected.
Speed and Duplex
You use this selection to configure a port for Auto-Negotiation or
to manually set a port’s speed and duplex mode.